Step
1
Remove end cap from base. Slide (2) side support
into base and secure (1) in place with a screwdriver. Replace
end cap. Keep the second extrusion loose to help install your
poster. Use a measuring tape or the cross bar to estimate the
width of your poster.
|
Step
2
Insert poster and lenses (at the same time)
into the grooved channels. Once installed, pull your extrusion
and lenses gently apart to relieve any "bubbles". Tighten
the second extrusion into the base.
|
Step
3
Slide the third side support into the base
and secure it in place with a screwdriver. Replace end
cap.
|
Step 4
Measure the desired height for each shelf. Attach and secure
each shelf bracket onto the side supports, using a Phillips
Head screwdriver and the provided Allen wrench.
|
Step 5
Insert each shelf and secure in place by
tightening each plastic set screw with a Flat Head screwdriver.
|
Step
6
Attach end cap to both side supports.
|