Summer Sale - Shop Here

How To Assemble Your WAVE SHELVING UNITS

Easy to do, but takes several minutes to construct. An assistant is also recommended.

     

You will need:

Phillips Head screwdriver
Flat Head screwdriver
Water level
Measuring tape
*All hardware is included.

Assembly Tips:

  • When tightening side extrusions to base, remember to keep the extrusion flush to the groove of the base. The extrusion tends to "rock" in the base groove, which if tightened this way, your display will not be perpendicular.
  • When measuring space for your poster and pockets, please remember to include the poster bars in your estimations.
  • The plastic lenses feature "bump-outs" to help guide your lenses down the grooves of the side extrusions.
  • If you are having difficulty inserting the shelves, loosen one of the side extrusions, and slide it slightly out the base to grant you more room.

  • Once you've attached your shelves, use a water leveler to ensure your shelves are level.

Step 1

Remove end cap from base. Slide both side support into base and secure in place with a screwdriver. Replace end cap.

Step 2

Measure the desired height for each shelf. Attach and secure each shelf bracket onto both side supports, using a Phillips Head screwdriver and the provided Allen key.

Step 3

Insert each shelf and secure in place by tightening the plastic set screw with your Flathead screwdriver.

 

Step 4

 

Attach end cap to both side supports.

Step 5

 

Your shelving unit is now set up and ready for accessories!