Instruction Guide for Wave Displays
Setting Up The Base
Before you begin to install your graphics, create the display's frame using the base and support arms. Remove the base end caps on either side, and slide the support arms into the base. Turn each screw on the support arms to tighten. After the screws are tightened and the frame is fitted securely into the base, replace the base end caps.
 
Installing Your Graphics
Have person on a stepladder that can reach the top of the support arms and another at the base level. Slowly feed your graphics and lenses into the side grooves. Continue sliding the graphics and lenses down along the tracks.
 
When you get to a curve, if the graphics resist moving, gently tap the graphics to follow the curve. Finish sliding the graphics until they reach the bottom of the frame. This is easiest if there is one person at the top feeding the graphics into the grooves, and one person at the bottom guiding them through. After the graphics are completely installed, place the end caps at the top of the supports.